The Influence of Radiation Modification on the Wear Resistance of Cutters Made of Carbide Material VK-8

The effect of gamma irradiation on some physico-mechanical and tribological properties of VK-8 cemented carbide was investigated. Samples were CNMG 120408-46 indexable cutting inserts (manufacturer “Sandvik MKTS”, Russia) intended for turning. They were subjected to gamma irradiation at various doses from 20 to 200 kGy and in different gaseous environments (air and nitrogen). Irradiation was carried out on an industrial GUD-300M facility using ⁶⁰Co sources. Tests showed that after irradiation, a decrease in the electrical resistivity of the samples was observed, confirming the hypothesis of microstructure ordering in the irradiated material. Hardness measurements before and after irradiation did not reveal significant changes. However, a significant increase in the wear resistance of the material during cutting of various steels was established, from 1.5 to 6 times, depending on the absorbed irradiation dose, the steel being machined, and the cutting parameters. It is suggested that there exists an “optimal” level of gamma irradiation, below and above which the effect of radiation modification decreases. Determining this level requires separate tests for each material studied. Nevertheless, general trends of increased wear resistance have been established in this article.

1. Oniskiv V.D., Stolbov V.Yu., Makarevich Yu.L., and Chunaev V.Yu. Some Results of Research into the Strength and Radiation Resistance of Carbon–Basalt Composite Materials // Polymer Science. Series D. — 2024 (17), no. 3, 725—730

2. Woods R. and Pikaev A. Applied Radiation Chemistry: Radiation Processing. — New York: Published by Jong Wiley and Sons Inc. — 1994

3. Oniskiv V., Stolbov V., and Ibragimova E. Effect of Gamma Irradiation on Morphology and Local Element Composition of Basalt-Based Composite Material // Journal of Digital Science. — 2023 (5), no. 2, 8—18

4. Timoshenko Yu.A., Klopotov A.A., Ivanov Yu.F. Changes in the structural and phase state of the WC8 alloy under the influence of a gamma-quantum flux // News of universities. Ferrous metallurgy. — 2001, no. 4, 40—43 (in Russian)

5. Makarov V.F., Pesin М.V., Nikitin S.P. Modern cutting tools for digital engineering. — Perm: Published by PNRPU. — 2025 (in Russian)

6. Vas Gary S. Fundamentals of radiation materials science. Metals and alloys. Series: World of materials and technologies. — Moscow: Technosfera. — 2014 (in Russian)

7. Obodovsky I.M. Radiation technologies. Application in laboratory research, materials science and nanotechnology. — Moscow: Intellect. — 2015 (in Russian)

8. Keizo M. and Song C. Radiation Processing of Polymer Materials and Its Industrial Applications. — New Jersey: Published by Jong Wiley and Sons Inc. Hoboken. — 2012

9. Oniskiv V.D., Sotin A.V., Stolbov V.Yu., Nikulin S.M., and Yuzhakova E.V. Biomechanical Aspects of Radiation Sterilization of Composite Material “Carbon FC” for Medicine // Russian Journal of Biomechanics. — 2023 (27). no. 4, 175—179

10. Ershov B.G. Radiation technologies: possibilities, status and application prospects. // Bulletin of the Russian Academy of Sciences. — 2013 (83), no. 10, 885—895 (in Russian)

11. Oskolkova T.N., Glezer A.M. Current state of the scientific problem of surface hardening of tungsten carbide hard alloys (review) // Bulletin of universities. Ferrous metallurgy. — 2017 (60), no. 12, 980—991 (in Russian)

12. Feynman R., Leighton R., and Sands M. Feynman Lectures on Physics 9. Quantum Mechanics. 2nd edn. — Moscow: MIR. — 1965

13. Chernov I.P., Mamontov A.P. Ordering of the crystal structure by ionizing radiation (the effect of low doses of ionizing radiation) // Bulletin of the Tomsk Polytechnic University. — 2000 (303), no. 1, 74—80 (in Russian)

14. Vorobyov V.L., Bykov P.V., Gilmutdinov F.Z., Bayakin V.Ya. Effect of N+ ion implantation on the surface morphology, chemical composition and atomic structure of the surface layers of stainless steel and titanium alloy // In: 14th International Ural Seminar Radiation Physics of Metals and Alloys. Abstracts of reports. — 2022, 61—62 (in Russian)

15. Didyk A.Yu., Vishnevsky R., Wilczynska-Kitowska T., Myshinsky G.V., Semin V.A. Synthesis of chemical elements under palladium gamma-ray irradiation in a condensed gas environment // RENSIT — 2019 (11), no. 2, 143—157 (in Russian)